JET 708320 Manuel d'utilisation et d'entretien

Operating Instructions and Parts Manual JWS-22CS Spindle Shaper WALTER MEIER (Manufacturing) Inc. 427 New Sanford Road LaVergne, Tennessee 3

10Collet Installation 1. Disconnect machine from the power source. 2. To set up the shaper for collet use, remove the arbor and clean the spindle t

11Table Ring Removal and Installation To remove the table ring(s): 1. Remove any collet or spindle assembly in the spindle. 2. Lower the spindle as

12Shaping with Collars and Starting Pin Follow these rules when shaping with collars and starting pin for safest operation and best results: 1. Coll

133. The collar between cutters method, shown in Figure 18, has both the advantages and disadvantages of the first two methods. This method is used

14Troubleshooting Trouble Probable Cause Remedy Shaper will not start. Cord unplugged from the power source. Plug in power cord. Fuse blown, or circ

15Trouble Probable Cause Remedy Raised areas on shaped edge. Variation of pressure holding work against cutter. Hold work firmly against table and f

16Table and Fence Breakdown

17Cabinet Breakdown

18Parts List Index No. Part No. Description Size Qty 1 ... JWS22CS-1 ...Table ...

19Index No. Part No. Description Size Qty 36 ... JTAS10-45 ...Handle ...

2 Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Au

20Index No. Part No. Description Size Qty 84 ... JWS18HO-84 ...Safety Shield ...

21Electrical Schematic

22Electrical Schematic for the Forward/Reverse Switch

23

24 WALTER MEIER (Manufacturing) Inc. 427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.walter

3 Table of Contents Warranty and Service...

4 Warning Wear eye protection. Be sure keyed washer is directly under the spindle nut and the spindle nut is tight. Feed the workpiece against the r

5 • MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for best and safest performance. Follow instructions for lubricating and changing accesso

6 Electrical Connections Electrical connections must be made by a qualified electrician in compliance with all relevant codes. This machine must be

7 Introduction The JET JWS-22CS woodworking shaper you have purchased is a high quality machine tool that will give you years of superior service. Yo

8 Unpacking and Cleanup 1. Finish removing all contents from the shipping container. Do not discard any shipping material until the shaper is set u

9 Adjustments Arbor Removal and Installation All adjustments to the machine must be made with the power off and unplugged from the power source.