Operating Instructions and Parts Manual Belt and Disc Sander Model J-41002 – 2" x 42" Belt and 8" Disc Sander WALTER M
10Installing Disc Table 1. Position the disc table at an angle, as shown in Figure 3, and slide the table on so that the trunnion slots fit over the
11Grounding Instructions This machine must be grounded while in use to protect the operator from electric shock. In the event of a malfunction or b
12Adjustments Tilting the Belt Table The belt table tilts from zero (horizontal) down to 45°. 1. Loosen the handle and adjust the table into desire
13Use of the Miter Gauge The miter gauge is used to sand accurate angles on workpieces. When using the miter gauge on the horizontal table position,
14Abrasive Belt Replacement 1. Unplug the Sander from the power source. 2. Unscrew and remove the two knobs on the belt cover. 3. Remove the belt
15Abrasive Disc Replacement 1. Unplug the sander from the power source. 2. Remove the dust cover and the disc table. To remove the disc table, remo
16Operation This sander is intended for dry sanding of metals. Do not use lubricants. Do not sand or polish magnesium; it may create a fire hazard.
172. Tighten the miter gauge securely so the miter reference angle will not shift while you are sanding. 3. Place the workpiece against the miter ref
18Maintenance Before performing any maintenance on the machine, disconnect it from the electrical supply by pulling out the plug or switching off t
19Troubleshooting Trouble Probable Cause Remedy Sander will not start. Not connected to power source. Connect to power source. Branch circuit fuse
2 Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Au
20Assembly Drawing
21Parts List Index No. Part No. Description Size Qty 1 ... J-41002-01 ...Base ...
22Parts List 57 ... TS-1505021 ...Socket Head Cap Screw ...M10x20 ... 2 58 ...
23Notes
24 WALTER MEIER (Manufacturing) Inc. 427 New Sanford Road LaVergne, Tennessee 37086 Ph.: 800-274
3 Table of Contents Warranty and Service...
4 Warning 1. Read and understand the entire owner’s manual before attempting assembly or operation. 2. Read and understand the warnings posted on
5 21. Make your workshop child proof with padlocks, master switches or by removing starter keys. 22. Give your work undivided attention. Looking ar
6 Introduction This manual is provided by Walter Meier (Manufacturing) Inc., covering the safe operation and maintenance procedures for a JET 2x42x8
7 Features and Terminology
8 Unpacking Open shipping container and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not disca
9 Assembly Tools needed for assembly: • 10mm open-end wrench • Cross-point (Phillips) screwdriver • Combination square, or similar angle measuring de
Commentaires sur ces manuels