JET 708749B Manuel d'utilisation et d'entretien télécharger pdf (Page 13)

Rail Assembly (optional accessory)

1. Attach the front rail (A, Fig. 8) to the cast iron

table with two 1/4” x 5/8” hex cap bolts, two

1/4” lock washers, and two 1/4” flat washers.

Bolts should be in approximately the center of

the slot. Hand tighten only at this time.

2. Attach the rear rail (B, Fig. 8) to the table with

two 1/4” x 5/8” hex cap bolts, two 1/4” lock

washers, and two 1/4” flat washers. Bolts

should be in approximately the center of the

slot. Hand tighten only at this time.

3. Push the front, and rear rails up as far as they

will go.

4. Tighten the four hex cap bolts holding the front,

and rear rails to the table. Do not over tighten

the bolts.

5. Attach the guide tube (C, Fig. 8) to the front rail

with five 1/4” x 5/8” hex cap bolts, five 1/4” lock

washers, and five 1/4” flat washers. Bolts

should be in approximately the center of the

slot.

Fence Assembly and Adjustment

(optional accessory)

1. Attach the fence (D, Fig. 9) to the fence body

(E, Fig. 9) with four 5/16” x 3/4” hex cap bolts,

four 5/16” lock washers, and four 5/16” flat

washers.

2. Thread a hex nut (G, Fig. 10) onto the pad’s

threaded stud (H, Fig. 10) and insert through

the fence and rear hook (I, Fig. 10). Secure in

place using a hex nut, lock washer and flat

washer (J, Fig. 10).

Note: The hook should be adjusted so that it

overlaps the rear rail by approximately 1/8”.

3. Place fence assembl

onto the

uide tube.

The rear hook should engage the rear rail.

Figure 8

Figure 9

Figure 10

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Pas de commentaire

JET 708749B Manuel d'utilisation et d'entretien Page 13