Operating Instructions and Parts Manual Combination Belt/Disc Sander Model JSG-6DC with optional open stand with optional c
10Unpacking Open shipping carton(s) and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not disca
11 Contents of Closed Stand Carton: (Optional Accessory – p/n 708598) See Figure 9. 1 Stand 1 Owner’s Manual (not shown) 1 Hardware Bag*, contain
12Assembly Tools required for assembly: 4mm Hex Key 6mm Hex Key (provided) 13mm open-end wrench (2) 11/16” wrenches or sockets Machine is heavy!
13 Note: The trunnion brackets are not identical; make sure the bracket with the raised indicator line is installed on the left side of the table. 4.
144. Rotate disc a half turn and press other half of abrasive into place. Make sure to remove any entrapped air by pressing all parts of the abrasiv
15Dust Collection It is strongly recommended that a dust collection system (not included) be connected to the sander. Mount a 4-inch hose to the sand
16Adjust 90° Stop 6. With the table locked at 90°, loosen the hex nut on the 90° stop, and adjust the set screw to seat against the stop block. See
174. If table is not parallel, loosen the four screws holding the table to the trunnions (B, Figure 25) with a 12mm wrench, and nudge the table unti
18Belt Tracking Adjustment The belt should run at the center of the belt arm without veering to the left or right. Check this as follows: 1. Disconn
19Troubleshooting Trouble Probable Cause Remedy Sander will not start. Sander unplugged from wall, or motor. Check all plug connections. Fuse blown
2 Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Au
20JSG-6DC Belt/Disc Sander Assembly
21Parts List for JSG-6DC Belt/Disc Sander Assembly Index No. Part No. Description Size Qty 1 ... 612001W ...Base ...
2255 ... 612028...Hinge ...
23115 ... NH101700 ...Nut * ...M10 ... 4 116
24Closed Stand Assembly (Optional) Index No. Part No. Description Size Qty ... 708598...Closed Stand Assembly Co
25Open Stand Assembly (Optional) Parts List for Open Stand Assembly (Optional) Index No. Part No. Description Size Qty ... 7
26Electrical Connections
27
28 WALTER MEIER (Manufacturing) Inc. 427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.walter
3 Table of Contents Warranty and Service...
4 Warning 1. Read and understand the entire owner’s manual before attempting assembly or operation. 2. Read and understand the warnings posted on
5 20. Cluttered areas and benches invite accidents. Keep the area around the machine clean and free of scrap material, oil and grease. 21. Keep vis
6 Introduction This manual is provided by Walter Meier (Manufacturing) Inc., covering the safe operation and maintenance procedures for a JET Model J
7 On/Off Switch Padlock The Sander is equipped with a push-button switch that will accept a safety padlock (not included). To safeguard your machine
8 Grounding Instructions Electrical connections must be made by a qualified electrician in compliance with all relevant codes. This machine must be
9 3. The 115V attachment plug (shown in Figure 6) supplied with the sander, must be replaced with a UL/CSA listed plug suitable for 230V operation (
Commentaires sur ces manuels